Due to the high volume of orders after FTC kickoff, there may be delays in shipping your order. Thank you for your patience!
JST-XHP-4 to Split Connect 0.1 in. Pins
1 - 4 units: $5.00
5 - 9 units: $4.50
10 or more units: $4.00
This is an encoder cable used to provide power and receive encoder signals from a Hall Effect Two Channel Encoder and break out each connection to a single pin perfect for a 2.54 mm pitch. This en...Read More
This encoder is provided on our RS775 motor, which is on our PG Gearmotors as well as the NeveRest motor, which is on these Gearmotors:
- NeveRest Orbital 20 Gearmotor
- NeveRest Classic 60 Gearmotor
- NeveRest Classic 40 Gearmotor
- NeveRest Orbital 3.7 Gearmotor
It has a common white connector on the end addressing the encoder and four individual female connections to fit into the input connector on a robot controller.
- Fitting Connections: 4-pin white connector (plugs into encoder)
- Gauge: 22 AWG
- Length: 19.5 in.
- Weight: 0.03 lbs
Important if you want to interface with the motor encoder. I had never tried it before. It's a good unit. It has high resolution! Worth it.
High quality cable
This cable is perfect for its use but could be a bit less expensive...perhaps $2.50 or $3.00. It could also simply be part of the motor it connects to. I will buy more of them when I order new motors.
Cable delivery was fine
All went well on this cable delivery. Your feedback regarding ship dates is critical and appreciated. Thanks
Will evaluate with FTC encoders during off season.
This will be used with some off season projects.