15 Tooth 32 DP 8 mm Round Bore Steel Pinion Gear for EVO
am-3482
$9.00
This gear is used as the input pinion gear for the EVO Shifter. This gear is a tight press fit onto a CIM gear, and requires at minimum a 3-ton arbor press to install. If a CIM motor with this gear...Read More
Product Overview
This gear is used as the input pinion gear for the EVO Shifter. This gear is a tight press fit onto a CIM gear, and requires at minimum a 3-ton arbor press to install. If a CIM motor with this gear pre-installed interests you, check out am-0255_15T.
Note about Pinions:
The EVO product line utilizes an included 15 Tooth 32DP pinion gear which does not use a key. If you are are unable or uncomfortable performing the following procedures we recommend purchasing a motor with the pinion pre-installed. They are available as am-0255_15T for the CIM or am-4258_15T for the NEO.
Note about Pinions:
The EVO product line utilizes an included 15 Tooth 32DP pinion gear which does not use a key. If you are are unable or uncomfortable performing the following procedures we recommend purchasing a motor with the pinion pre-installed. They are available as am-0255_15T for the CIM or am-4258_15T for the NEO.
- When using a NEO motor a 3 ton arbor press is required to install this pinion due to the intended interference fit (0.001 - 0.002") Please follow the NEO Press Fit Pinion Guide. This press fit procedure has been tested to have a factor of safety of 3.5 on a NEO.
- When using a CIM motor the pinion may be a slip fit or a press fit (as above) due to the manufacturing tolerances of these motors. In either case apply a few rings of red Loctite 271 to the shaft and inside the pinion, then press the pinion on using the provided aluminum spacer (am-3552) to set the depth from the end of the motor shaft (approximately 0.40"). Red Loctite 271 has been tested to a factor of safety of 4 on a CIM when let to cure for 24 hours.
Specifications
- Bore: 0.312 in. Round
- Diametral Pitch: 32
- Face Width: 0.531 in.
- Length: 0.8 in.
- Material: 1117 Steel
- Pitch Diameter: 0.469 in.
- Pressure Angle: 20 Degrees
- Teeth: 15
- Thickness: 0.75 in.
- Weight: 0.02 lbs
Documents
CAD File(s)
Layout Print(s)
Don't see what you need?
Returns
Returns are accepted within 30 days of purchase.
View our return policy here.
Recommendations
3 reviews
-
good gear good service
good gear good service
-
Review
5 Stars
-
Review
5 Stars