15 Tooth 32 DP 8 mm Round Bore Steel Pinion Gear

am-3482

$10.00

This gear is used as the input pinion gear for the EVO Shifter.Pinion Installation:The 15 Tooth 32DP pinion gear does not use a key for torque transfer. There are two possible methods of installati...Read More

View Full Details

Product Overview

This gear is used as the input pinion gear for the EVO Shifter.


Pinion Installation:
The 15 Tooth 32DP pinion gear does not use a key for torque transfer. There are two possible methods of installation of this pinion on a CIM or NEO style motor. In both methods an aluminum spacer (am-3552) can be used to set the depth from the end of the motor shaft if using these pinions in any of our EVO gearboxes that require it. 

  • If the tolerances of both the motor shaft and the pinion are in your favor an arbor press (possibly up to 3 tons) is required to install this pinion due to the intended interference fit (0.001 - 0.002") 
    • If using an original NEO motor Please follow the NEO Press Fit Pinion Guide.
    • If using a NEO 1.1 Motor insert a #10-32 x 3/8in long socket head screw into the hole in the back of the motor to support the internal shaft while pressing pinions
    • If using a CIM or MiniCIM simply place the motor vertical on the arbor press taking care not to crush the wires, and press the pinion down the the desired location on the shaft. 
  • If the tolerances are not in your favor and the pinions slip on the shaft, or you feel that the press fit it too weak, an adhesive is required to transfer torque. The procedure is the same for all motors.
    • Apply a few rings of red Loctite 271 to the shaft, and the bore of the pinion, then slip the pinion onto the shaft down the the desired location.
      • Red Loctite 271 has been tested to a factor of safety of 4x the stall torque of a CIM when let to cure for 24 hours.

If you are are unable or uncomfortable performing these procedures, we recommend purchasing a motor with the pinion pre-installed. They are available as am-0255_15T for the CIM or am-4258a_15T for the NEO.

Specifications

  • Bore: 0.312 in. Round
  • Diametral Pitch: 32
  • Face Width: 0.531 in.
  • Length: 0.8 in.
  • Material: 1117 Steel
  • Pitch Diameter: 0.469 in.
  • Pressure Angle: 20 Degrees
  • Teeth: 15
  • Thickness: 0.75 in.
  • Weight: 0.02 lbs

Returns

Returns are accepted within 30 days of purchase.
View our return policy here.

4 reviews

  1. star star star star star 5 out of 5 stars

    I purchased 10 of these pinions and not a singl...

    I purchased 10 of these pinions and not a single one was a press fit, all were slip fit. We are using these on our drive train. Our entire FRC season is now on the fact that the Locktite 271 will hold. Not a really good feeling.

    SP from Ocean Springs

    Verified Purchaser

  2. star star star star star 5 out of 5 stars

    good gear good service

    good gear good service

    gG

    Verified Purchaser

  3. star star star star star 5 out of 5 stars

    Review

    5 Stars

    jt from Alamo

  4. star star star star star 5 out of 5 stars

    Review

    5 Stars

    DD from Winter Park

Top of Page