16T 20DP 10mm Round Bore with 4mm Keyway, Steel Gear

am-2088

$12.00

This gear can be used on the any of the PG Series Gearmotors, fitting on the 10mm output shaft.

Product Overview

This gear can be used on the any of the PG Series Gearmotors, fitting on the 10mm output shaft.

Specifications

  • Bore: 10mm (0.395") diameter hole w/ 4mm (0.158") keyway
  • Diametral Pitch: 20
  • Face Width: 0.55"
  • Material: 4140 steel, cold formed into gear teeth
  • Overall Width: 0.58"
  • Pitch Diameter: 0.8"
  • Pressure Angle: 14.5 Degrees
  • Teeth: 16
  • Weight: 0.08 lbs

Recommendations

5 reviews

  1. star star star star star 5.0 out of 5 stars

    Review

    5 Stars

  2. star star star star empty_star 4.0 out of 5 stars

    Nicely made

    Well built, but soft enough to shred some teeth.

  3. star star star star empty_star 4.0 out of 5 stars

    Good Gear, but need a better key

    Note the am-1249 4mm key is not quite the right size for this gear and the PG motors. The Key needs to be taller (~5mm). With the right key I think this would be a good gear, but the am-1249 will loosen up and fall out if not held captive. Even with the key being held captive we found that the gear/shaft interface would get sloppy with use.

  4. star star star star star 5.0 out of 5 stars

    Good strong gear

    I can use this with confidence of durability. Nice part

  5. star star star star star 5.0 out of 5 stars

    Gearmotor drive gear

    This is a great product to make available since the motor is primarily metric and matching gears can be hard to find. The only thing I would have appreciated is providing a shaft key. I did find a source for these so it works out OK. The gear design details helped select matching gears.

Top of Page