Home > Wheels > Pneumatic Wheels >

Hub Assembly for 6 in. Pneumatic Wheel (am-2469)
Hub Assembly for 6 in. Pneumatic Wheel (am-2469)
Price: $16.00

Stock Status:(Out of Stock)

Info Downloads
Product Overview:
This is the strong polycarbonate plastic hub for a 6 inch Pneumatic Wheel. This product is shipped in kit form.

  • Weight:0.35 pounds
  • Width: 2.188 inches
  • Material: black polycarbonate plastic
  • Bore: 0.96 inch thru hole, with 1.125 inch x 0.375 inch deep bearing pockets
  • Bolt Pattern: 6 holes, 0.20 diameter on 1.875 inch diameter bolt circle
  • Outside Diameter: 3.375 inches
Included Hardware:
  • Two (2) black plastic hub halves
  • Six (6) #4-40x1 Pan Head Phillips thread rolling screws
NOT Included Hardware:
  • bearings
  • #10 screws and nuts needed to mount a hub (2 inch long screws are needed) or a sprocket (2.25 inch long screws are needed)
  • tire and inner tube: Any 150x50mm tire and inner tube can fit this hub, as long as the inner tube has a 90 degree valve stem.
Wheel Structure:
The hub halves are held together with the #4-40 screws. This wheel can accept #10-32 screws for mounting sprockets or hubs, but these are NOT included since different length screws are needed to mount hubs or sprockets. These #10 screws can be mounted to the included 1.875 inch diameter bolt circle. The hub halves need to be assembled together so that the valve stem clearance holes line up. Locating features are present for easy alignment.

With Axle and Hub:
  • In order to drive this wheel with a hub, use Hardware Kit 11, which includes #10-32x2 screws (6) and #10-32 nylock nuts (6)
With Sprocket:
  • In order to drive this wheel with a plate sprocket, use Hardware Kit 12, which includes a 550 sprocket spacer, #10-32x2.5 screws (6) and #10-32 nylock nuts (6).
  • Two (2) bearings are needed for this wheel, if being driven by a sprocket. Use bearings with a 1.125 inch outer diameter. No flange is needed on either of the bearings.
Use as a caster:
  • If you want to let this wheel spin without being driven, you will need to install two (2) bearings with 1.125 inch outer diameter.

Average Customer Review: 4 of 5 Total Reviews: 1 Write your own review!

  0 of 0 people found the following review helpful:
Nice Wheels February 1, 2016
Reviewer: Rob Stehlik from Toronto, ON Canada  
The plastic rims for 6" pneumatic wheels are very light and fit perfectly. The only minor issue I have with the design is the valve stem is a bit difficult to access once assembled.

Was this review helpful to you?

Browse products in the same categories:

Wheels > Pneumatic Wheels
Browse ALL Products